13-pin towbar connector 900, 9000, 9-3

English

Delen op sociale netwerken

Koppeling delen

Gebruik permanente koppeling om te delen via sociale media

Deel met een vriend

Alstublieft in te loggen voor het versturen van deze document per e-mail!

In uw website insluiten

Kies de startpagina

3. 86 79 227 3 Saab 900 M94-, Saab 9000, Saab 9-3 6 Connect the wiring harness to the connector as illustrated. 7 Connect the thick RED cable and the RED/ BLACK cable to the enclosed 2-pin connector, pin 1 and pin 2 for positive feed and charging respectively. 8 Tape the connector to the wiring harness if posi- tive feed and charging is not being fitted. 9 Connect the black ground lead to the grounding point under the rear left lamp cluster. 10 Connect the 8-pin connector to the car’s pre- pared harness. D930A085 YE/RD BK BU/WH BU/BN BK RD/WH BU WH GN GY RD RD/BK YE - - 4 5 - 3 6 1 2 7 - - - 9 10 7 6

4. 4 86 79 227 Saab 900 M94-, Saab 9000, Saab 9-3 11 If a prepared wiring harness for a towbar has not been factory fitted, fit the BLUE/WHITE cable for the rear light. 12 Connect the cable to pin 7 in the 8-pin connector under the rear left lamp cluster. Shunt the WHITE cable to the 4-pin connector (pin 3 located above the rear left wheel hous- ing). 13 Secure the harness in a suitable position with a cable tie. 14 9-3: Fit the fuse (10A) in the main fuse board at position B. 15 Check the function and refit all dismantled com- ponents. D930A086 12

6. 6 86 79 227 Saab 900 M94-, Saab 9000, Saab 9-3 7 -87: Cut off the flat pins on the green cable (pin 2) and blue cable (pin 6). Strip and twist together the ends of the cables. Fit a new flat pin. Connect the flat pin to pin 2 in the 8-pin connec- tor. 8 Connect the thick RED cable and the RED/ BLACK cable to the enclosed 2-pin connector, pin 1 and pin 2 for positive feed and/or charging respectively. 9 Connect the black ground lead to the grounding point under the rear left lamp cluster. 10 Connect the 8-pin connector to the car’s pre- pared towbar wiring harness. 11 Connect the extra rear light cable (WHITE/ BLUE) to the 8-pin connector at pin 7. Shunt the WHITE cable to pin 3 on the 10-pin connector behind the rear left wheel housing. 12 Check the function and refit all dismantled com- ponents. C930A019 9 11 8 7

7. 86 79 227 7 Saab 900 M94-, Saab 9000, Saab 9-3 Wiring diagram, 13-pin towbar connector A WH 1.0 RD/WH 1.0 GY 1.0 GN 1.0 BU 1.0 BK 4.0 BU/BN 1.0 BU/WH 1.0 Z X 5 8 7 2 1 6 4 3 8 7 6 12 11 BK4.0 2 1 9 10 13 3 1 2 4 5 RD4.0 RD/BK 4.0 BK 2.5 258 DT13P94 990416 258 Connector in car A 1 Direction indicator LH 2 Fog lights 3 Ground 4 Direction indicator RH 5 Parking light RH 6 Brake lights 7 Parking light LH 8 Reversing lights 9 Power supply 10 Charging 11 - 12 - 13 Ground

2. 2 86 79 227 Saab 900 M94-, Saab 9000, Saab 9-3 Saab 900 M94-, Saab 9-3 1 Fold aside the rear left side trim. 2Drill a ∅ 25 mm hole with a hole saw as illu- strated. Corrosion protect the hole. Deburr the hole and remove loose cuttings and flakes of paint. Clean with Teroson Cleaner FL. Apply Standox 1K Füllprimer. Apply finishing paint. Apply Terotex HV 400 (part no. 30 15 930) inside cavities. 3 Screw the 13-pin connector to the holder on the towbar. 4 Insert the wiring harness into the luggage compartment harness 5 Fit the rubber grommet WARNING Take care with the wiring harness running along the rear plate. D930A082 2 4 3 5

5. 86 79 227 5 Saab 900 M94-, Saab 9000, Saab 9-3 Saab 9000 1 Bend aside the rear left side trim. 2 Remove the protective cover over the rear left lamp cluster. 3 5D: Remove the rubber plug in the rear panel. 4 Screw the 13-pin connector to the holder on the towbar. 5 5D: Run the wiring harness into the luggage compartment. 4D, CS: Run the wiring harness to the luggage compartment through the opening for the removable towing eye 6 Fit the rubber grommet. C930A016 4 2 5 6

1. Saab 900 M94-, Saab 9000, Saab 9-3 900 Monteringsanvisning SCdefault MONTERINGSANVISNING · INSTALLATON INSTRUCTIONS MONTAGEANLEITUNG · INSTALLATIONS DE MONTAGE SITdefault Saab 900 M94-, Saab 9000, Saab 9-3 13-pin towbar connector 1 Towbar 2 2-pin connector 3 8-pin connector 4 Wiring harness for rear light 5 Screw (3x) 6Nut (3x) 7 Shunt 8 Rubber grommet 9 Cable tie (2x) 10 Cable tie (3x) 11 Fla t pin 12 Fuse 10A Accessories Part No. Group Date Instruction Part No. Replaces 400 112 082 3:71-08 Jul 99 86 79 227 75 03 98 Jul 93 51 06 711 Apr 99 D930A084 10 11 1 3 2 5 9 6 8 7 12 4

Weergaven

  • 661 Totale weergaven
  • 541 Websiteweergaven
  • 120 Ingesloten weergaven

Acties

  • 0 Gedeeld op sociale media
  • 0 Vind-ik-leuks
  • 0 Vind-ik-niet-leuks
  • 0 Opmerkingen

Aantal malen gedeeld

  • 0 Facebook
  • 0 Twitter
  • 0 LinkedIn
  • 0 Google+

Insluitingen 4

  • 10 saabpartners.com
  • 18 www.saabpartners.com
  • 2 52.29.207.161
  • 5 54.154.214.138