Centre armrest, driver’s seat 9-3

English / Saab 9-3

Delen op sociale netwerken

Koppeling delen

Gebruik permanente koppeling om te delen via sociale media

Deel met een vriend

Alstublieft in te loggen voor het versturen van deze document per e-mail!

In uw website insluiten

Kies de startpagina

2. 2 5033840 Saab 9-3 1 Push the seat forward as far as possible. 2 Undo the rear of the seat, 2 bolts. 3 Push the seat back and undo the 2 front bolts. 4 Tilt back the seat and undo the cable tie, the rub- ber straps and the 29-pin connector under the seat. 5 Lift out the seat, detaching the belt if necessary. Keep the covers under the seat rails. 2 3 4 D980A098

3. 50 33 840 3 Saab 9-3 6 Cut the cable tie securing the plastic protector and remove the protector from the side of the seat, 1 screw. 7 Loosen the strap/straps securing the bottom of the backrest upholstery. 8 Cut the cable ties (2 pcs.) and unplug the con- nector. 9 Remove the airbag connector from the 29-pin connector. 10 Undo the upholstery strips at the bottom. 11 Pull out the cables through the hole in the uphol- stery. 12 Pull out the cardboard from the backrest uphol- stery. D980A099 12 7 6 10 11 10

4. 4 5033840 Saab 9-3 13 Undo the back of the backrest upholstery by loo- sening the upholstery strip along the sides and folding back the upholstery. 14 Remove the lumbar support adjustment knob. 15 Undo the upholstery strip along the edge on the back of the backrest frame. 16 Remove the padding between the upholstery and the backrest frame. Keep the plastic. Make holes in the padding at the pre-punched recess 17 Where necessary, remove the cover plate from the pre-punched hole in the backrest frame, three screws. D980A100 16 14 12 17 13

7. 50 33 840 7 Saab 9-3 27 Remove the storage tray in the centre console between the seats. Bend out “the ears” and pull up. 28 Fit the new tray. D980A103 34 33

6. 6 5033840 Saab 9-3 25 Refit the backrest upholstery by replacing the strips along the sides. 26 Insert the cardboard into the backrest uphol- stery. 27 Insert the cables through the hole in the uphol- stery. 28 Refit the upholstery strip at the bottom. 29 Secure the cables, plug in the connectors and fit cable ties. 30 Attach the strap/straps to the bottom of the backrest upholstery under the seat cushion. 31 Fit the lumbar support adjustment knob. 32 Fit the plastic protector to the inboard side of the seat. Secure the cable to the seat belt lock with a cable tie so that the head of the fastener is poin- ting down. 26 28 28 25 31 32 D980A102 27

5. 50 33 840 5 Saab 9-3 18 Fit the mounting into the seat. Tightening torque: 3.5 Nm (2.6 lbf ft) 19 Fit the padding. 20 Refit the upholstery strip along the rear edge of the backrest frame. 21 Locate the position of the holder and cut a cross in the upholstery with a sharp knife. 22 Undo the upholstery strip again. 23 Fit the upholstery onto the armrest. 24 Fit the armrest to the mounting. Tightening torque: 3.5 Nm (2.6 lbf ft) Notera Take care not to split the upholstery. 24 18 18 18 D980A101 24 24

1. Saab 9-3 9-3 Monteringsanvisning SCdefault MONTERINGSANVISNING · INSTALLATION INSTRUCTIONS MONTAGEANLEITUNG · INSTALLATIONS DE MONTAGE SITdefault Saab 9-3 Centre armrest, driver’s seat 1 Armrest frame assembly LHD 2 Screw, rounded head (3 pcs) 3 Rear cover assembly Accessories Part No. Group Date Instruction Part No. Replaces 400 109 864 400 109 872 9:88-9 Feb 99 50 33 840 50 33 840 Oct 98 D980A097 1 3 2

8. 8 5033840 Saab 9-3 35 Lift the seat into the car and tilt it back. Plug in the 29-pin connector under the seat and fit cable ties. 36 Refit the seat belt if previously removed. 37 Put the seat in place. 38 Thread in the front bolts without tightening them. 39 Place the covers under the seat rails. 40 Move the seat forward and fit the rear bolts. • Manual seat: Check the legroom adjustment so that the seat locks on the right and left- hand sides. 41 Tighten the rear seat bolts. Tightening torque: 24 Nm (18 lbf ft) 42 Move the seat as far back as possible. • Manual seat: Check the legroom adjustment so that the seat locks on the right and left- hand sides. 43 Tighten the front seat bolts. Tightening torque: 24 Nm (18 lbf ft) 40 38 35 D980A104

Weergaven

  • 1243 Totale weergaven
  • 1083 Websiteweergaven
  • 160 Ingesloten weergaven

Acties

  • 0 Gedeeld op sociale media
  • 0 Vind-ik-leuks
  • 0 Vind-ik-niet-leuks
  • 0 Opmerkingen

Aantal malen gedeeld

  • 0 Facebook
  • 0 Twitter
  • 0 LinkedIn
  • 0 Google+

Insluitingen 4

  • 28 www.saabpartners.com
  • 6 52.29.207.161
  • 14 saabpartners.com
  • 3 54.154.214.138