Mudflaps, rear 9-3

English

Delen op sociale netwerken

Koppeling delen

Gebruik permanente koppeling om te delen via sociale media

Deel met een vriend

Alstublieft in te loggen voor het versturen van deze document per e-mail!

In uw website insluiten

Kies de startpagina

2. 2 12 798 022 Saab 9-3 M03- 1 Mudflap L 2 Mudflap R 3 Screw (x8) 4 Clip nut (x4) F980A154 4 1 2 3

1. Saab 9-3 M03- 900 Installation instructions SCdefault MONTERINGSANVISNING · INSTALLATION INSTRUCTIONS MONTAGEANLEITUNG · INSTRUCTIONS DE MONTAGE SITdefault Saab 9-3 M03- Mudflaps, rear Accessories Part No. Group Date Instruction Part No. Replaces 12 786 785 9:84-20 Oct 04 12 798 022 12 798 022 Aug 02 F980A153

6. 6 12 798 022 Saab 9-3 M03- 14 Right-hand side: Refit the wing liner. 15 Right-hand side: Fit the mudflap. Check the fit against the bumper and adjust as necessary. F980A158 15 15 14

3. 12 798 022 3 Saab 9-3 M03- 1 Raise the car. 2 Remove both rear wheels. 3 Left-hand side: Remove the bolt mounted underneath and the lower edge of the wheel housing. 4 Left-hand side: Fit the mudflap against the wing liner. Use the mudflap as a drilling template. 5 Left-hand side: Use a 6 mm bit to drill 2 holes to match the holes in the mudflap and then put the mudflap aside. Important Do not apply pressure as that could damage the wing liner. F980A155 3 4 3 5 5

4. 4 12 798 022 Saab 9-3 M03- 6 Left-hand side: Use a knife to make a groove from underneath where the lower clip nut shall be fitted (the location is illustrated looking from the back of the wing liner). 7 Left-hand side: Carefully prise out the wing liner and fit the clip nuts. 8 Left-hand side: Refit the wing liner. 9 Left-hand side: Fit the mudflap. Check the fit against the bumper and adjust as necessary. F980A156 8 9 6 9

7. 12 798 022 7 Saab 9-3 M03- 16 Clean all dirt and rust from the contact surfaces of the wheel and brake disc. 17 Apply white high-pressure grease (part no. 30 06 442) to the hub. 18 Aluminium wheels: Oil the bolt threads and the conical surface of the bolts. 19 Position the wheel, fit the bolts and tighten these in sequence by hand to centre the wheel. 20 Tighten the bolts in sequence twice. Tightening torque 110 Nm (81 lbf ft) 21 Repeat steps 16-20 on the right-hand side of the car. 22 Lower the car. Important Make sure that no grease gets onto the contact surfaces of the wheel and brake disc. Important The wheel should be freely suspended during tightening. F980A159 17 16

5. 12 798 022 5 Saab 9-3 M03- 10 Right-hand side: a All: Remove the screw which is fitted under- neath and the screw in the rear edge of the wing liner. b Cars with air shield: Remove the screw which is fitted in the lower edge of the wheel housing. 11 Right-hand side: Fit the mudflap against the wing liner. Use the mudflap as a drilling template. 12 Right-hand side: Use a 6 mm bit to drill holes to match the holes in the mudflap and then put the mudflap aside. 13 Right-hand side: a All: Carefully prise out the wing liner and fit the clip nut. b Cars without air shield: Use a knife to make a groove from underneath where the lower clip nut shall be fitted. c Cars without air shield: Fit the clip nut. Important Do not apply pressure as that could damage the wing liner. F980A359 11 10a 13a 13c 13b 10a 10b

Weergaven

  • 548 Totale weergaven
  • 463 Websiteweergaven
  • 85 Ingesloten weergaven

Acties

  • 0 Gedeeld op sociale media
  • 0 Vind-ik-leuks
  • 0 Vind-ik-niet-leuks
  • 0 Opmerkingen

Aantal malen gedeeld

  • 0 Facebook
  • 0 Twitter
  • 0 LinkedIn
  • 0 Google+

Insluitingen 5

  • 12 www.saabpartners.com
  • 2 52.29.207.161
  • 5 saabpartners.com
  • 1 52.211.236.180
  • 4 54.154.214.138