Sill covers 9-5 1

English

Delen op sociale netwerken

Koppeling delen

Gebruik permanente koppeling om te delen via sociale media

Deel met een vriend

Alstublieft in te loggen voor het versturen van deze document per e-mail!

In uw website insluiten

Kies de startpagina

2. 2 54 96 153 Saab 9-5 1 Left-hand sill cover 2 Right-hand sill cover 3 Plastic nut (x12) 4 Nut (x2) 5 Bolt (x2) E980A159 1 2 3 5 4

3. 54 96 153 3 Saab 9-5 The sill covers have been treated with grey primer and are ready for painting. Paint the sill covers the same colour as the body; see “Directions for painting preprimed PP/EPDM plastic” in these installation instructions. First fit the sill cover on one side of the car, then on the other. 1 Remove the screw holding the front wheel arch liner to the sill cover. 2 Carefully bend away the rear, lower section of the front wheel arch liner and remove the nut that holds the scuff plate to the front fender (wing). 3 Remove the rubber moulding. 4 Remove the screws and plastic nuts holding the sill cover to the body. 5 Remove the lower front plastic nut of the rear wheel arch liner. 6 Carefully bend out the front edge of the wheel arch liner and the sill cover so that the sill cover releases from the bolt. 7 Lift away the sill cover. E980A160 5 6 1 2 7 3 4 4

4. 4 54 96 153 Saab 9-5 8 Carefully bend out the front edge of the rear wheel arch liner and hang the sill cover on the bolt. 9 Fit and adjust the front edge of the sill cover to the edge of the front fender (wing) wheel housing. 10 Carefully bend aside the front wheel arch liner and tighten the new nut holding the sill cover to the wheel arch liner. 11 Screw in the sill cover using the screws and the new plastic nuts. 12 Fit the new bolt that is to hold the front wheel arch liner to the sill cover. 13 Fit the rubber moulding starting at the rear of the sill cover. Important Start from behind and raise the sill cover as the screws are tightened. E980A161 8 8 9 11 10 13 11 12

1. Saab 9-5 900 Installation instructions SCdefault MONTERINGSANVISNING · INSTALLATION INSTRUCTIONS MONTAGEANLEITUNG · INSTRUCTIONS DE MONTAGE SITdefault Saab 9-5 Sill covers Accessories Part No. Group Date Instruction Part No. Replaces 400 132 601 400 133 278 9:84-21 Aug 03 54 96 153 54 96 153 May 03 E980A192

5. 54 96 153 5 Saab 9-5 Directions for painting preprimed PP/ EPDM plastic • Place the sill covers in such a way as they will not be distorted while painting. • The temperature must not exceed +40 °C (104 °F). • The sill covers are primed on delivery. • Use clean gloves when handling the sill covers. Drying time 70 minutes at 40 °C (104 °F). Preparations • Rub down the primed surfaces thoroughly. Use 3M 1200 or 800 abrasive paper.

Weergaven

  • 665 Totale weergaven
  • 538 Websiteweergaven
  • 127 Ingesloten weergaven

Acties

  • 0 Gedeeld op sociale media
  • 0 Vind-ik-leuks
  • 0 Vind-ik-niet-leuks
  • 0 Opmerkingen

Aantal malen gedeeld

  • 0 Facebook
  • 0 Twitter
  • 0 LinkedIn
  • 0 Google+

Insluitingen 5

  • 15 www.saabpartners.com
  • 9 52.29.207.161
  • 6 saabpartners.com
  • 1 52.211.236.180
  • 4 54.154.214.138