Splash guard, front 9-3

English

Delen op sociale netwerken

Koppeling delen

Gebruik permanente koppeling om te delen via sociale media

Deel met een vriend

Alstublieft in te loggen voor het versturen van deze document per e-mail!

In uw website insluiten

Kies de startpagina

2. 2 12 798 021 Saab 9-3 M03- 1 Splash guard L 2 Splash guard R 3 Bolt (x6) 4 Clip nut (x2) F980A107 3 2 1 4

3. 12 798 021 3 Saab 9-3 M03- 1 Raise the car. 2 Remove the front left wheel. 3 Remove the bolts in the lower part of the left-hand wheel housing's rear edge. 4 Align the splash guard. Press firmly in the cor- rect position and mark the upper hole position. 5 Remove the splash guard. 6 Drill a 6 mm (0.25 in) hole in the location of the marking. 7 Fold out the wheel arch liner and fit a clip nut over the drilled hole. 8 Fit the wheel arch liner. 9 Fit the splash guard. F980A108 7 9 6 4 4 3

1. Saab 9-3 M03- 900 Installation instructions SCdefault MONTERINGSANVISNING · INSTALLATION INSTRUCTIONS MONTAGEANLEITUNG · INSTRUCTIONS DE MONTAGE SITdefault Saab 9-3 M03- Splash guard, front Accessories Part No. Group Date Instruction Part No. Replaces 12 786 784 12 831 787 9:84-19 Mar 03 12 798 021 12 798 021 Apr 02 F980A106

4. 4 12 798 021 Saab 9-3 M03- 10 Clean all dirt and rust from the contact surfaces of the wheel and brake disc. 11 Apply white high-pressure grease (part no. 30 06 442) to the hub. 12 Position the wheel, fit the bolts and tighten these in sequence by hand to centre the wheel. 13 Tighten the bolts in sequence twice. Tightening torque aluminium rim 110 Nm (81 lbf ft) pressed steel rim 50 Nm +2x90°, max 110 Nm (37 lbf ft +2x90°, max 81 lbf ft) 14 Repeat steps 2-13 on the right side of the car and lower the car. Important Make sure that no grease gets onto the contact surfaces of the wheel and brake disc. Important The wheel should be freely suspended during tightening. Note In order to avoid the bolts being tightened too hard when fitting pressed steel wheels, tightening through a further quarter-turn must be carried out using a torque wrench set at 110 Nm (81 lbf ft). If the torque wrench indicates that 110 Nm (81 lbf ft) is achieved, discontinue tightening through a fur- ther quarter-turn. F980A109 10 11

Weergaven

  • 571 Totale weergaven
  • 486 Websiteweergaven
  • 85 Ingesloten weergaven

Acties

  • 0 Gedeeld op sociale media
  • 0 Vind-ik-leuks
  • 0 Vind-ik-niet-leuks
  • 0 Opmerkingen

Aantal malen gedeeld

  • 0 Facebook
  • 0 Twitter
  • 0 LinkedIn
  • 0 Google+

Insluitingen 4

  • 3 www.saabpartners.com
  • 5 saabpartners.com
  • 3 52.29.207.161
  • 5 54.154.214.138