Wood/Leather gearlever knob and leather gaiter 9-5

English

Delen op sociale netwerken

Koppeling delen

Gebruik permanente koppeling om te delen via sociale media

Deel met een vriend

Alstublieft in te loggen voor het versturen van deze document per e-mail!

In uw website insluiten

Kies de startpagina

3. 47 77 041 3 Saab 9-5 Fitting 1 Turn the leather gaiter inside out and fit it over the gear lever. 2 Fasten the leather gaiter to the reverse gear detent's carrier by pulling the metal wire taut round the gaiter so that it engages in the carrier's groove. 3 Tighten the metal wire with a pair of pliers and wrap the ends round the gaiter a few turns. Cut off the wire about 5 mm from the gaiter and bend the ends down so that they do not damage the gaiter. 4 Pull the gaiter down over the gear lever. 5 Clean the splines on the tubular metal lever with benzine or the like. 6 Check that the spring is fitted. 7 Apply two-component epoxy adhesive to the gearlever knob. NOTE: make sure that the adhesive covers the inside surface of the knob. 8 Fit the knob on the splines and rotate it to distribute the adhesive evenly. 9 Check that the figure "4" on the knob faces to the rear, see illustration. 10 Press the reverse gear detent's carrier upwards so that the three catches engage with the knob. 11 Raise the gaiter slightly and press the knob down over the splines until the carrier's stop is a maximum of 0-0.5 mm above the reverse gear detent's stop lug. 12 Fasten the gaiter to the frame in the centre console. 13 Leave the adhesive to harden. 14 Place the fitting instructions in the car. 11 2 9 E471A003

2. 2 47 77 041 Saab 9-5 Removal 1 Put the gear lever in neutral. 2 Remove the emblem. 3 Saw a slit in the original knob and remove the black outer plastic casing. 4 Remove the tape so that the three snap fasteners for the reverse lock actuator can be released. 5 Split the white plastic core with a hacksaw. 6 Tear off the plastic core with a pair of adjustable pliers or similar tool. 7 Detach the bottom of the rubber gaiter. 8 Detach the gaiter from the reverse gear detent’s carrier. Important Saw only down to the metal tube. 23 4 57 E471A002

1. Saab 9-5 900 Monteringsanvisning SCdefault MONTERINGSANVISNING · INSTALLATION INSTRUCTIONS MONTAGEANLEITUNG · INSTALLATIONS DE MONTAGE SITdefault Saab 9-5 Wood/Leather gearlever knob and leather gaiter 1 Gearlever knob 2Gaiter 3 Securing wire (metal) Accessories Part No. Group Date Instruction Part No. Replaces 400 107 108 400 107 124 9:43-1 July 96 47 77 041 12 3 E471A001

Weergaven

  • 541 Totale weergaven
  • 454 Websiteweergaven
  • 87 Ingesloten weergaven

Acties

  • 0 Gedeeld op sociale media
  • 0 Vind-ik-leuks
  • 0 Vind-ik-niet-leuks
  • 0 Opmerkingen

Aantal malen gedeeld

  • 0 Facebook
  • 0 Twitter
  • 0 LinkedIn
  • 0 Google+

Insluitingen 4

  • 15 www.saabpartners.com
  • 2 52.29.207.161
  • 8 saabpartners.com
  • 2 54.154.214.138